Our services include performance of conceptual design work together with the analysis and optimization of production technology. Keep in mind that "G" code programming and editing is always an option. DELTA-CAD MODERN PROJECT AND PRODUCTION COMPANY Our specialization is the professional design and creation of 3D components from plastics, composites, and metals. It would probably be more difficult to locate the NC code on a nested job, but is doable. Anyway, this would provide a smooth ellipse with actually very little trouble for a counter top. When you create the geomtry you will need to account for the radius of the bit for tool compensation, since a G41 or G42 can not be used with a G12 or G13. Ease of use was the primary design feature of Delta Cad. Change the G01's to G12 (clockwise ellipse) or G13 for a counter-clockwise ellipse. Delta Cad - Worlds easiest CAD program, CAD software Worlds easiest CAD program CAD software should not be hard to use With DeltaCad you can be creating your first CAD drawing within minutes. When the NC file is created from Control Nesting find the four straight lines in the program. Someone mentioned IntelliCad, that product is very, very similar to AutoCad, so that may have the same variable.Īnother option for machining on a Thermwood and not for display in eCabinets would be to create a diamond, i.e. So you may be able to import dxf file of an ellipse from AutoCad with the setting changed. I don't remember which, but it was usable with our old DXF translator and would cut a nice ellipse. If you are using Autocad there is a system variable for an ellipse called "pellipse" that can be set to 0 or 1. You can use Tangency Factor codes to nullify some of that or maybe not. For one, the intersection of the arcs would probably be out of tangency enough to cause a chatter mark or some mark at the intersections. Of course, the more arcs you use the closer you'll get, but that could be a lot of work, if you had to draw each arc. My thoughts are that the geometry for a 3 point arc would get you close particularly for display purposes in eCabinets, but maybe not for machining. So if you don't have CAD/CAM software with a post, you would need to import a dxf file using Control Nesting to cut the counter top. Since I'm not a math guru I wont' get into that.įirst, the geometry for a counter top will not export with the cabinet or job file to create the. An ellipse is one of those geometric shapes that is very complex mathematically.
0 Comments
Leave a Reply. |